Jump to content

Recommended Posts

Here's what the factory service manual says:

 

WARNING:

Do not touch bulb while it is lit or right after being turned off. Burning may result.

CAUTION:

•  Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.

•  Do not leave the bulb out of the lamp reflector for a long time because dust, moisture, smoke, etc.may affect the performance of the lamp.

1.    Remove the back door finisher. Refer to INT-21, "Removal and Installation".

2.    Rotate  license  plate  lamp  socket  (1)  counterclockwise  and remove.

3.    Remove license plate lamp bulb from bulb socket.

 

The "back door finisher" is the plastic panel on the inside of the door.  Fortunately, that step is pretty simple: "Release the clips, using a suitable tool, then remove the back door finisher (RH) from the back door."

 

The owner's manual says to use a W5W bulb.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...