jwilson

That looks like it is way past shimming spacing possibilities. The people that have shimmed were just barely rubbing on the door.  I am not sure if you shimmed it that far out if the door would close properly.

Gotcha. Time to get custom....my fab guys will have to get creative. Thanks for the response...

Sure. The wheels are 20x10 (I can't remember the offset because we took these off our other NV. The tires are 285/55/R20 Toyo Open Country. The door opens half way and then slides up against tire. It was the same on last NV and we dealt with it but on the new one she doesn't want to have the door restricted anymore.
 

What is the width and offset of your wheels? What tire size did you go with? Could you post some pictures of how far the tires stick out?

So I put some wheels and tires on the NV 3500 and the sliding door rubs on the wheels maybe 1/4".

I've seen a couple people post on here about "shimming" the door or adding washers as spacers on

the mount area. Any ideas? Looking at replacing the inner door panel with some sheet metal but would

rather just space the door out....

Any ideas please throw them my way. Wife isn't too happy the door won't slide open all the way.

I actually just added 3 stainless steel washers at the lower hinge point on the rail.

do you happen to have a picture of that install? my wheel / tire combo is about the same and it rubs. looking for

best way to get door to slide past them better....

I had to shim my door with my 285's... how did you shim yours? Add stud extenders to the door?

how did you shim your door? it rubs on my tires so I need to find a way so bump the door out