Dennis.Moore

I looked there. They wanted $210.00

takes all day if you've got all the parts I've been riding around all week with my dashboard dissembled Still no answer n the VSS wire :-/

Replacing my Clarion stock radio with a JVC 7" DVD GPS Reciever KW-NT800HDT Had to pop out the right hand vent (use a plastic tool to prevent marring the dash). That exposed the two right radio panel screws. Had to pull drivers side kick plate (one screw under fuse block panel and pop it off) to expose one screw on right side of instrument panel cover (pop it off) That exposes the two left screws of the radio panel cover. remove four cover screws and you find four radio screws. Clarion radio had a power/speaker wire plug I ordered an adapter - Scosche NN04B 2007-Up Nissan Car Stereo Connector also had an antenna plug I ordered it's adapter- Scosche NAA2B 2007 Nissan Antenna Adapter Ran rear speaker wires under door floor plates that popped up. Around the pillar by lifting cover (near seat belt mount) out a bit. and popping off lower right passenger side floor kick plate (pops out) also ran my Bazooka boom box wires and rear view camera wires in that path. Was able to run the gps wire up the drivers side by removing the pillar cover (pops out) and the little speaker grill then tucking wire between window and dash and mounting it in the center under the window. May replace the door speakers (4"X6") and add 3.5" dash speakers. Now I'm searching for the vehicle speed sensor wire. anyone know where it is? (engine control module recieves vehicle speed signals from ABS actuator and transmission control module via controller area network)

http://www.adriansteel.com Got mine from Adrian steel for my 30 footer. Grab handle Sticks out on the right side so watch for trees. I have 3 ladders strapped above the bins against the sidewall.