Jump to content
Ryan Stotts

Where to find upfitter connector

Recommended Posts

This unused plug near the driver side kick panel is the upfitter plug?

 

Where do I get the plug for it? Preferably with a pigtail.

 

IMG_2371.jpg

Edited by Ryan Stotts

Share this post


Link to post
Share on other sites

.

 Have you looked for and found a source for the mating plugs to make a clean way of using these pre-wired locations? On Page 168 it shows two locations in the engine compartment to tap into. They would be handy ones to use for adding Aux lighting (fog lamps, driving lights, etc), it would be nice to find the female plugs for them also.

Share this post


Link to post
Share on other sites

It turns out those connectors in the engine compartment are the other end of the ones under the dash.  No power to any of it and I never sourced the connectors.   

Share this post


Link to post
Share on other sites

Well, that is interesting, I didn't check to see if there was power to them, I guess I shouldn't have assumed there was, but was just thinking that if the manual referenced them as uplifts, they would have power to them. I have a couple of places to check on connectors, I'll post if I find some. 

Share this post


Link to post
Share on other sites

This is a copy of my post under the upfits thread:

 

For anyone who is looking for the disconnects to put inside the two prong upfitter connector they are 9.53mm female disconnects. They go in with a very satisfying click and don't budge once they are in place.

 

The same disconnects are used on both the engine side and the cab side even though the upfitter connector is different.

 

I'm using them on the cab side as well, just without a upfitter connector until I can find it. Slide them on and put electrical tape around the housing to keep dust and dirt out.

 

Available Amazon and ebay if you search for:

 

TE CONNECTIVITY / AMP 280755-4 TERMINAL, FEMALE DISCONNECT, 9.53MM, CRIMP (10 pieces)

 

Pics and write-up on my Instagram page:

 

https://www.instagram.com/p/BWvG-JNFLiu/

 

You can use mini fuse tap adapters to connect power on the cab side if you need it. Some things will make sense to connect there and some will make sense to connect on the engine side.

 

Pictures and write up here:

 

https://www.instagram.com/p/BWALKDsFVKK/

 

I actually did have the correct disconnects for the four prong connector as well. Search this Amazon or eBay:

 

Uxcell Metal Female Spade Terminal for Nylon Multi-Pin Connector, 1.5 mm Width 50 Pieces

 

Write up here:

 

https://www.instagram.com/p/BW5r7PTlCqV/

Edited by Mdsnyder108

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...