nihil_perditi Posted October 17, 2015 I have a feeling the answer is right under my nose but for some reason I have not been able to find a document outlining information regarding the reinforced cargo mounting points for the van. I am especially interested in knowing what size bolt will fit in the threaded mounting points (assuming it will be a metric one versus standard) as well as what is the safest load/ shear force (in lbs) these mounting points can handle. Any information regarding where Nissan has documented this or any knowledge you have obtained through your own experience is greatly appreciated! Thanks. Quote Share this post Link to post Share on other sites
axulsuv Posted October 17, 2015 I'm pretty sure they are 6mm x 1.5 or 1.25 don't remember which .I beleive there is a upfitters guide somewhere with the loading info your after. Chris C.M. might chime in with some better info ...Glenn Quote Share this post Link to post Share on other sites
nihil_perditi Posted October 20, 2015 Glenn, Thanks for this information. I also reached out to the dealer I purchased my van from to see what information (if any) they might be able to share. I will pass on anything they share. Quote Share this post Link to post Share on other sites
nihil_perditi Posted October 20, 2015 Well I noticed a link to a document in another thread on this forum that has the information I was looking for. Looks like the majority throughout are M8 x 1.25 Link:http://www.nissan-techinfo.com/bbg.aspx Quote Share this post Link to post Share on other sites
mahu Posted October 21, 2015 could you post the link again? the link you provided is broken/incomplete. Thanks a bunch! Quote Share this post Link to post Share on other sites
nihil_perditi Posted October 22, 2015 Hopefully this works: http://www.nissan-techinfo.com/bbg.aspx Quote Share this post Link to post Share on other sites
mahu Posted October 23, 2015 Yes, now it works! Thanks a bunch! Quote Share this post Link to post Share on other sites
mahu Posted July 2, 2016 I think there is a mistake in the manual. It says wall points are M8 x 1.25 while roof points are M6 x 1.0. The M8 x 1.25 I got fit perfectly into the roof so M6 would be too small. Question: Is there a need to use some kind of thread locking to prevent the bolts from loosening over time? 1 it-treker reacted to this Quote Share this post Link to post Share on other sites
wollip Posted July 2, 2016 Yes - use it. Worth the trouble. Too many vibrations even on good roads. Been too long since I dealt with the bolts. Seems like I remember the cargo lights had a different sized bolt. 1 it-treker reacted to this Quote Share this post Link to post Share on other sites