Glidedon

Thanks for all your posts regarding your conversion DesertTed

So you have the stock head unit still?

What's this spin on trans filter you speak of ?

I attach mine to the visor clips meant for business cards or something.

Nice work, you got just what you wanted.

I financed my 2013 NV through Nissan for 0% for 4 years.

Does anyone know what wire the remote start taps into, in order to activate the stater motor? Okay I found it. Yellow wire, in white plug at back of ignition switch.

I'll be in OR or ID weather dependent

Also if you unlock the doors and don't open a door it will re-lock itself after a short time.

I mounted a winch between the front seats to pull my Vstrom 650 up a ramp and use a wheel chock and the tie down rings.

Looks good DesertTed. Thanks for posting. I want to do this too, have you seen a window that opens and fits in the same spot?

If I'm going on a long trip and I've got 40 to 50 thousand miles on my belts and hoses I change them. I keep the old belt and hoses in the vehicle in case I end up somewhere where they are not available, could save a lot of time waiting.

Thanks for posting this Gman65

The vent will fit between ribs. You will cut a little bit of the flanges but it does not structurally weaken the rib.

There are some beep tones associated with the nav system that can be toggled o on and off in the menu.

you there?

I installed etrack using self tapping screws. I wanted to keep factory mounts available for other uses. Keep in mind when using etrack you should secure your load stresses on a shear bias to the fasteners holding your etrack in place. Do not secure load buy pulling straight away from fastener.if you use self tapping screws.

I would like to know more about the winch mount.

Yes please part numbers and specific Titan kit. I would like to lift mine also.

Great build details DesertTed, love it. What vent cover are you using? and how are those mounting bits secured to the van?

I notice the rear end sags a bit on my V6 high top cargo with nowhere near capacity weight. Maybe he notice the rear end sagging on your van. I'm going to put airbags on my van to keep it in a level attitude.

Okay, the dealer had the window out for the fourth time and decided to replace gasket because of the number of times it had been reused. While removing and cleaning the surfaces a 3/16 hole was discovered in the body seam just above the windshield. The hole was "fixed" and the windshield reinstalled. Let's hope this is the end of this headache.

I've had mine get stuck and not open . It mainly happens when the door is not closed firmly and just barely latched.

Mine is back in for the fourth time. I will report back.

Looks good. Where did you buy the window rain shields? Do you recommended the seller and product? Thanks!